3/14/2023 0 Comments Markx phase dimmingUp to 30% of the unit’s capacity may be used for incandescent lighting. Incandescent and electronic low-voltage sources may be controlled on the same circuit/control zone.Electronic (solid-state) low-voltage transformer (must be manufacturer approved for reverse-phase control dimming).Load (output) power: Phase independent of control device/control voltage.Models available for 120 V only or 120-277 V load voltage.Up to 3 power modules may be controlled by a single dimmer.Phase-adaptive technology automatically selects leading-edge or trailing-edge dimming for low-voltage transformers.May be used to dim incandescent, halogen, electronic low-voltage, magnetic low-voltage, neon/cold cathode, Lutron TuWire™, or Advance Mark X® lighting sources.When connected to a 20 A circuit breaker, provides capacity on a 3-wire fluorescent dimmer for a full 16 A load of lighting.Top Phase-Adaptive Power Module with 3-Wire Fluorescent Input May be used with GFI/AFI breaker protected loads.Magnetic and electronic fluorescent dimming ballasts.Electronic (solid-state) low-voltage transformer.120 V control power, 120-277 V load power, 50/60 Hz, phase-to-neutral.Model available for 120-277 V load power.Model available for 120 V control power.Provides power and switching for one zone.Utilizes Softswitch® arcless switching technology.May be used to switch incandescent, electronic low-voltage, magnetic low-voltage, HID, fluorescent ballasts, and neon/cold cathode lighting sources.Provides capability for a zone on a GRAFIK Eye control unit (or other product) to switch a fully loaded circuit of lighting.Maximum heat output of module: 15 BTU/hour.Module protects itself during temporary over-current conditions on dimmed output.Operates Lutron HI-Lume® and Eco-10® (Eco Series) line-voltage control electronic dimming ballasts with a smooth continuous Square Law dimming curve. Uses Softswitch® arcless switching technology.Provides capability for a zone on a GRAFIK Eye control unit (or other product) toĭim fluorescent lights that have Lutron HI-Lume® and Eco-10® (Eco Series) line-voltage control electronic dimming ballasts.Maximum heat output of module: 135 BTU/hour.Relative humidity less than 90% non-condensing. Power module is UL tested and approved for use in air plenums. Two LEDs on front of unit provide diagnostic information (visible when faceplate is removed).Module protects itself during temporary over-current and over-voltage conditions.Patented RTISS™ circuitry compensates in real time for incoming line voltage variations:Ĭompensates for ☒% change in RMS voltage/cycle and ☒% Hz change in frequency/second.Automatically selects between forward phase/leading edge (e.g., magnetic low-voltage) and reverse phase/trailing edge (e.g., electronic low-voltage) dimming based on load.Use switching power module for non-dim loads. Incandescent and electronic low-voltage sources may be controlled on the same zone.Lutron TuWire™ electronic fluorescent dimming ballast.Magnetic low-voltage transformer (iron core).Operates these sources with a smooth continuous Square Law dimming curve:.Load (output) power: Phase independent of control unit.120 V control power, 120 V or 120-277 V load power, 50/60 Hz, phase-to-neutral.Models available for 120 V or 120-277 V load power.Models available for 120 V control power.Up to 3 power modules may be wired on a single GRAFIK Eye zone. ![]() Provides power and dimming for one zone.Automatically selects leading-edge or trailing-edge dimming for low-voltage transformers.May be used to control incandescent, electronic low-voltage, magnetic low-voltage, and neon/cold cathode lighting sources, as well as Lutron TuWire™ fluorescent dimming ballasts.Provides capability for a zone on a GRAFIK Eye control unit (or other product) to dim a fully loaded circuit of lighting.Downloads Grafik Eye Guide (pdf) Grafik Eye 3000 Series Selection Guide (pdf)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |